Audinate Dante-MY16-AUD Betriebsanweisung PDF herunterladen (Seite 17)

Dante Firmware Update Manager User Guide

Version 1.10 Commercial in Confidence Page 17 of 19

Finding devices for safe recovery...

This screen indicates that Firmware Update

Manager has detected Type 1 devices in safe

mode, and is scanning the network for the full list. It

should take less than a minute to find all applicable

devices.

When you are sure that all your safe mode devices

have been found, click Stop Scan, and go to step 3

below.

Some older Dante-MY16-AUD and DLM devices

may not appear in the failsafe recovery device list.

If you have either of these devices in failsafe and

they are not appearing in the failsafe device list,

see the note regarding 'Expanded Search' below.

Incompatible Safe Mode Devices

This screen indicates that you have two types of

devices (for example, Brooklyn II devices and

Ultimo devices) in safe mode on your network. Only

one type of device can be recovered at a time.

Click Back, disconnect either the Type 1 devices or

Type 2 devices (it doesn't matter which at this

point), and click Failsafe Recovery again. You will

then see one of the two screens shown

immediately below.

When you have restored one type of devices,

repeat the process for the other type.

Matching Devices Found

This screen means that Firmware Update Manager

has detected Type 2 devices in safe mode.

Type 2 devices can be restored using the standard

firmware update procedure, as described in Section

7.2 - Basic Steps (step 7 onwards).

1 2 ... 12 13 14 15 16 17 18 19

Keine Kommentare

Audinate Dante-MY16-AUD Betriebsanweisung Seite 17