Audinate Dante-MY16-AUD Betriebsanweisung PDF herunterladen (Seite 15)

Dante Firmware Update Manager User Guide

Version 1.10 Commercial in Confidence Page 15 of 19

 Each device will be updated in turn, taking 2-4 minutes per device

 As each device is updated, the device Status column will change to 'Updating (n/m)'

 When all sections are updated for a device, the device will show 'Done'

 When all devices have been updated, the following message will be shown:

Figure 4 - Upgrade complete notification

9. Power cycle the Dante-enabled devices that have been upgraded, to finish applying the firmware update

and restore your configuration. If the device is not power cycled or rebooted, the update will not be

applied.

8. About Failsafe

8.1. What is failsafe mode?

All Dante hardware modules use software loaded from Flash memory as part of their operation.

As with any storage device, it is possible to corrupt the data on the Flash part, potentially rendering it

unusable, if there are interruptions while writing to the Flash device.

By far the most common way for this to occur as with other Flash devices is by losing power to the Dante-

enabled device in the middle of a firmware upgrade.

To provide recovery from this event, Dante hardware modules have a special protected part of the Flash

memory that will run in the event the main part is corrupted.

When this is run, the module is in “failsafe mode”, and will wait for a recovery image to be provided by the

Firmware Update Manager.

8.2. How do I tell if a device is in failsafe mode?

By viewing the device in the Dante Controller.

A Dante device that is in failsafe mode will appear with its default device name in red in the default network

grid view of Dante Controller (versions 3.1.x and above).

1 2 ... 10 11 12 13 14 15 16 17 18 19

Keine Kommentare

Audinate Dante-MY16-AUD Betriebsanweisung Seite 15